Recording The System's Source To External Equipment; Adjusting The Input Level - JVC FS-X1 Manual De Instrucciones

Using External Equipments
Recording the System's Source
to External Equipment
You can record the System's source to external equipment
which is connected to the LINE OUT or OPTICAL DIGI-
TAL OUT terminal of the System, such as tape deck or MD
recorder, etc.
❑ First make sure that the external equipment is properly
connected to the System. (See page 8 to 9).
❑ When recording a FM or AM program, use the LINE
OUT terminal (not the OPTICAL DIGITAL OUT termi-
nal).
1
Play the System's CD Player or tune in
to a station.
❑ The recording level is not affected by the VOLUME level
set by the System. Also it is not affected by the sound ef-
fects.
• For operation of the external equipment, refer to its In-
structions.
21

Adjusting the Input Level

If the sound from the component connected to the LINE IN
jacks is too loud or is not loud enough when changing the
source to the external component (without adjusting the
volume level), you can change the input level through the
LINE IN jacks.
On the Remote Control
1
When the source is "LINE", press and
hold the SET button.
• If you have changed the source name of the external
component, the currently selected source will appear
(see page 20).
Press the 3 or 2 button to select an
2
appropriate input level.
• Each time you press the button, the input level alter-
nate between "INPUT LEVEL1" and "INPUT
LEVEL2".
INPUT LEVEL1: Select this when the sound is not loud
enough.
INPUT LEVEL2: Select this when the sound is too loud.
3
Press the SET button to finish the
adjustment.
• "LEVEL2 STORED" appears on the display.
• The selected input level will be kept in memory until
you change it.
The input level is too high.
• Select "INPUT LEVEL2" if the current level is "INPUT
LEVEL1".
• If the current level is "INPUT LEVEL2", adjust the output
level on the external component.