Tips And Recommendations For Installation - SOMFY Irismo Wirefree Manual Del Usuario

EN
2.3.3. Checking the direction of rotation (Fig6)
1) Press the Open button on the RTS remote control:
a) If the motorised product opens (a), the direction of rotation is correct.
b) If the motorised product closes (b), the direction of rotation is incorrect: Move onto the next step.
2) Press the my button on the RTS remote control until the motorised product moves: The direction of rotation has
been modified.
3) Press the Open button on the RTS remote control to check the direction of rotation.
If need to change the directing of rotation, refer 3.4.4
2.3.4. Recording the RTS control point (Fig 7)
Press the PROG button on the back of the remote control until the motorised product moves. The remote
control address is permanently recorded.
2.3.5. Adjusting the Touch motion sensitivity (Fig 8)
1) Press the Open and Close buttons of the RTS remote control simultaneously until the motorised product moves.
LED is yellow, the motor enter touch motion sensitivity setting mode
2) Press the Open and Close buttons simultaneously until the motorised product moves to switch from high sensitivity,
to low sensitivity, to no touch motion, and back to high sensitivity.
- yellow LED fast blink for high sensitivity
- yellow LED slow blink for low sensitivity
- yellow LED on for no touch motion
3) Press the my button until the motorised product moves to confirm the setting.
2.3.6. Adjusting the speed (Fig 9)
1) Press the Open and my buttons simultaneously until the motorised product moves.
Green and red LED blink alternatively, the motor enter speed setting mode
2) Press the Open button to increase the speed, or the Close button to decrease the speed.
There are 4 speed options: 12.5 cm/s (default speed) - 15 cm/s- 17.5 cm/s- 20 cm/s.
3) Press the my button until the motorised product moves to confirm the setting.

2.4. TIPS AND RECOMMENDATIONS FOR INSTALLATION

2.4.1. Questions about the Irismo Wirefree
Observations
The motorised product
does not operate.
6
Possible causes
The battery pack is weak.
The remote control battery is weak.
The remote control is not
compatible.
The remote control used has not been
programmed into the motor.
Check whether the battery pack is
weak and charge it.
Check whether the battery is weak and
replace it if necessary.
Check for compatibility and replace the
remote control if necessary.
Use a programmed remote control or
program this remote control.
Copyright © 2016 Somfy SAS. All rights reserved
Solutions
.