Tips And Recommendations For Installation; Use And Maintenance; Tips And Recommendations For Use; Technical Data - SOMFY Movelite WT Manual De Instrucciones

EN
2.3.2. Checking the direction of rotation (Fig E)
Move the curtain away from the end limits.
1) Press the Open button on the control point:
a) If the motorised product opens (a), the direction of rotation is correct.
b) If the motorised product closes (b), the direction of rotation is incorrect: Move onto the next step.
2) Press the Open , Stop and Close buttons, simultaneously until the motorised product moves
3) Press the Stop button, until the motorised product moves, to reverse the rotation direction.
4) Press the Open button on the control point to check the direction of rotation.

2.4. TIPS AND RECOMMENDATIONS FOR INSTALLATION

2.4.1. Questions about the Movelite
Observations
The wiring is incorrect.
The motorised product does
The control point is not
not operate.
compatible.
2.4.2. Erasing the memory of the motor (Fig F)
Press and hold the Open, Stop and Close buttons simultaneously until the motorised product moves 3 times.
All the settings are erased.

3. USE AND MAINTENANCE

This drive is maintenance-free
3.1. OPEN AND CLOSE BUTTONS
Pressing the Open or Close button fully opens or closes the motorised product.
3.2. STOP FUNCTION
The motorised product is moving.
Briefly press Stop: the motorised product stops automatically.

3.3. TIPS AND RECOMMENDATIONS FOR USE

3.3.1. Questions about the Movelite
Observations
The motorised product
The motorisation is in thermal protection mode.
does not operate.
If the motorised product still does not work, contact a motorisation and home automation professional.

4. TECHNICAL DATA

Power supply
Operating temperature
Index protection rating
Safety level
6
TM
?
Possible causes
(Fig G)
(Fig H)
TM ?
Possible causes
Copyright © 2018 SOMFY ACTIVITÉS SA, Société Anonyme. All rights reserved.
Solutions
Check and reconnect the power supply
Check for compatibility and replace the
control point if necessary.
Solutions
Wait for the motor to cool down.
100V - 240V
0°C to + 60°C
IP 30
Class I