3M Self-Rescue Manual Del Usuario página 16

5.0 INSPECTION
5.1 INSPECTION FREQUENCY: The Self-Rescue System must be inspected at the intervals defined in Section 1. Inspection
procedures are described in the "Inspection and Maintenance Log" (Table 2). Inspect all other components of the Fall
Protection System per the frequencies and procedures defined in the manufacturer's instructions.
5.2 DEFECTS: If inspection reveals an unsafe or defective condition, remove the Self-Rescue System from service
immediately and contact 3M regarding replacement or repair. Do not attempt to repair the Fall Arrest System.
;
Authorized Repairs Only: Only 3M or parties authorized in writing my make repairs to this equipment.
5.3 PRODUCT LIFE: The functional life of the Fall Arrest System is determined by work conditions and maintenance. As long
as the product passes inspection criteria, it may remain in service.
6.0 MAINTENANCE, SERVICING, STORAGE
6.1 CLEANING: Periodically clean the Self-Rescue System's metal components with a soft brush, warm water, and a mild
soap solution. Ensure parts are thoroughly rinsed with clean water.
6.2 SERVICE: Only 3M or parties authorized in writing by 3M may make repairs to this equipment. If the Self-Rescue System
has been subject to fall force or inspection reveals an unsafe or defective conditions, remove the system from service and
contact 3M regarding replacement or repair.
6.3 STORAGE AND TRANSPORT: When not in use, store and transport the Self-Rescue System and associated fall protection
equipment in a cool, dry, clean environment out of direct sunlight. Avoid areas where chemical vapors may exist.
Thoroughly inspect components after extended storage.
7.0 RFID TAG
7.1 LOCATION: 3M product covered in these user instructions is equipped with a Radio Frequency Identification (RFID) Tag.
RFID Tags may be used in coordination with an RFID Tag Scanner for recording product inspection results. See Figure 13
for where your RFID Tag is located.
7.2 DISPOSAL: Prior to disposing of this product, remove the RFID Tag and dispose/recycle in accordance with local
regulations. For more information, please visit our website: http://www.3M.com/FallProtection/RFID
8.0 LABELS
8.1 LABELS: Figure 16 illustrates labels on the Self-Rescue System. Labels must be replaced if they are not fully legible.
1) Applicable Standards
A
2) Model Number, Serial Number, and Max Descent Height
3) Manufactured (Year/Month) and Lot Number
4) Product Specifications
5) User Capacity
6) Read all instructions.
7) Product Use Instructions
1) Warning Statement - Inspect device according to User Instructions.
B
2) Inspection Log
1) Caution - Open bag with care.
C
1) Rescue Pole Use Instructions
D
1) Warning Statement - Do not use this component for Fall Arrest, Work Positioning, or Rescue applications.
E
16