Setting The Fax-Error-Correction Mode; To Change The Error-Correction Setting - HP LaserJet 3380 Manual De Instrucciones

Setting the fax-error-correction mode

Normally, the device monitors the signals on the telephone line while it is sending or
receiving a fax. If the device detects an error during the transmission and the error-
correction setting is On, the device can request that the portion of the fax be resent. The
factory-set default for error correction is On.
You should turn off error correction only if you are having trouble sending or receiving a fax,
and you are willing to accept the errors in the transmission. Turning off the setting might be
useful when you are trying to send a fax overseas, or receive one from overseas, or if you
are using a satellite telephone connection.

To change the error-correction setting

1. Press
2. Use the
3. Use the
4. Use the
5. Use the
selection.
ENWW
/ .
MENU ENTER
< or the > button to select Fax setup, and then press
< or the > button to select All faxes, and then press
< or the > button to select Error correction, and then press
< or the > button to select On or Off, and then press
MENU
/
MENU ENTER
/
MENU
Setting the fax-error-correction mode
/ .
ENTER
.
/ .
MENU ENTER
to save your
ENTER
65