How To Replace Receiver; Maintenance; How To Clean Your Ceiling Fan Blades - Fanimation The Landan FPD8087 Serie Manual Del Usuario

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

How to Operate Your Ceiling Fan (Cont'd)

5. "D" and "ON" dip switch:

The "ON" selection is the light dimmable selection and is

to be used with all bulbs except bulbs other than CFL.

The "D" selection is the light on only (no dimming

function) and is to be used with CFL bulbs as CFL bulbs

cannot be dimmed.

The receiver provides the following protective function:

1. Lock position: The DC motor has a built-in safety

against obstruction during operation. If something stuck

the fan. The motor will be stopped and disconnect power

after 30 seconds of interruption. Please remove obstacles

before re-set.

2. Over 80W protection: When the receiver detects motor

power consumption which is greater than 80W, the receiver

power will be stopped and operation will immediately

discontinue. Turn the receiver power on after 5 seconds.

(Figure 27)

1. Remove motor coupler cover by unscrewing the

two screws. (Figure 28)

2. Unplug antenna, signal wire and 9-PIN connector then

replace new receiver. (Figure 29)

3. Tight the two screws from the motor coupler cover.

(Figrue 30)

4. After installing new receiver to your fan, operate the

remote "Code Setting" process on "How to operate your

ceiling fan" Step 3 again.

1. Periodic cleaning of your new ceiling fan is the only

maintenance that is needed. When cleaning, use

only a soft brush or lint free cloth to avoid

scratching the finish. Abrasive cleaning agents are

not required and should be avoided to prevent

damage to finish.

How to Clean Your Ceiling Fan Blades

Periodic light dusting of the blades is recommended.

A feather duster will work best.