Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Night-time work or poor visibility conditions
Working at night or in poor visibility conditions increases
the risks arising from machine use; in these conditions,
Transporting the work vehicle
WARNING
For work vehicle loading/unloading, use lifting
equipment with a suitable capacity for the load to be
lifted.
Use all possible caution when lifting to avoid damag-
ing the work vehicle and causing injuries to persons
involved in operations.
Strap up the unit at the lifting points envisaged by the
manufacturer.
See the strap-up points and lifting procedures in the sec-
tions titled "Lifting the work vehicle" on page 11.
Anchor the work unit to the means of transport with
ropes and secure the wheels with wedges.
UN41-0505MM
To load the work vehicle onto the means of transport,
proceed as follows.
1) Start the tractor and lift the work vehicle as far off the
ground as is permitted.
2) Get into the means of transport from the tractor's
driving seat.
3) Lower the work vehicle onto the truck bed.
English language
INFORMATION FOR USE
proper lighting must be provided to ensure safe work.
Units which are narrower than the maximum width al-
lowed by the Highway Code can be loaded , coupled to
the tractor, onto suitable means of transport using load-
ing ramps.
WARNING
Thoroughly clean the ramps and loading platform
before boarding the vehicle.
Position the ramps on the transport means and fix
them in a stable way to the truck bed using the fas-
tening devices (pins, screws, chain etc.).
Where the ramps meet the truck bed there is a dan-
gerous bump so move the machine very carefully
over this point.
4) Off the tractor engine and engage the parking
brake.
5) Unhitch the work vehicle from the tractor.
6) Anchor the work unit to the means of transport with
ropes and secure the wheels with wedges.
7) Affix the relative signalling signs to any parts jutting
out from the means of transport.
32
6
Use and maintenance
Publicidad
Tabla de contenido
