Connector Options; Dynamic Alignment - Össur FLEX-RUN FXS008xyy Instrucciones De Uso

ENGLISH
FLEX-RUN SYSTEM (Figure 1)
TM
• Custom foot for recreational sports activities
• Preferred long distance running foot
• Build Height: 261mm (10 1/4"), clearance: 208mm (8 3/16")
• Maximum weight 130 kg (285 lbs)
• Endoskeletal attachment options

CONNECTOR OPTIONS

• Pyramid Adapter FWX00030 (1–6)
• Female Pyramid CM 150161 (1–6)
• Female Pyramid CM 150162 (7–9)
• Attachment plate FWX40001 must be added when using male or
female adapter.
• Roughen top surface of Flex-Run (Figure 2) and attachment plate
FWX40001
• Mix Siegelharz and apply to both surfaces
• Bond both parts together and clamp securely using a greased center
bolt and the connector part
• Disassemble after resin has set and trim off excess
• Clean parts, assemble and torque using Loctite 410 to following
specifications:
Center bolt
Pyramid angulation
BENCH ALIGNMENT (Figure 3 & 4)
SAGITTAL PLANE
• Place the ground contact point of the foot module 25–40 mm (1–1½")
in line with load line.
• Determine the appropriate socket flexion according to amputee
requirements.
CORONAL PLANE
• Introduce appropriate socket abduction/adduction.
• Allow for up to 5° of external rotation.
• Achieve proper height approximately 25–50 mm (1–2") taller than the
sound side with shoe to compensate for vertical compression.
Note: The recommendations for bench alignment are used as a
starting point. Definitive alignment will be achieved during dynamic
assessment.

DYNAMIC ALIGNMENT

Physical ability and length of residual limb will affect alignment. Best
performance will be achieved with best achievable symmetry of gait. Each
athlete will have her/his own optimal alignment, which depends on the
individual's running style. Optimal alignment is critical in order to reduce
energy expenditure and eliminate excessive muscle and ligament strain
while running:
4
M10 41 Nm (30 lbs)
M12 43 Nm (32 lbs)
M 8 15 Nm (9 lbs)