Metra AT-512CR Instrucciones De Instalación página 17

Ocultar thumbs Ver también para AT-512CR:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Dodge Caravan/Chrysler
Town & Country/Plymouth
Voyager 1996-2000
1. Pull the ashtray forward.
2. Unsnap the plastic trim piece located below
the radio trim bezel and remove (2) Phillips
screws exposed.
3. Remove (2) Phillips screws above the radio opening.
4. Unclip the dash trim bezel, disconnect the climate
control wiring and remove the bezel. (Figure A)
5. Remove (2) 3/8" hex-head screws securing the
factory head unit and disconnect the wiring.
6. Cut and remove all mounting tabs on the radio
housing EXCEPT shaded tabs. (Figure B)
Continue to kit assembly, page 25
(Figure A)
(Figure B)
Dash Disassembly
Dodge Charger/Plymouth
Turismo 1983-1987
1. Unclip the radio trim bezel and remove. (Figure A)
2. Remove (2) 3/8" hex-head screws securing the
factory head unit and disconnect the wiring.
3. Cut and remove all mounting tabs on the radio
housing EXCEPT shaded tabs. (Figure B)
Continue to kit assembly, page 25
(Figure A)
(Figure B)
17
Dodge Dakota
1987-1996
1. Remove (8) torx-head screws from the dash trim bezel.
2. Remove (2) Phillips screws from the lower steering
column trim and remove.
3. Remove (1) Phillips screw from each side of the
steering column.
4. Unclip the dash trim bezel and remove. (Figure A)
5. Remove (2) Phillips screws securing the factory
head unit and disconnect the wiring.
6. Cut and remove all mounting tabs on the radio
housing EXCEPT shaded tabs. (Figure B)
Continue to kit assembly, page 25
(Figure A)
(Figure B)

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Aw-512crCf-512crIbr-512cr

Tabla de contenido