Ford Aerostar 1985-91 - Metra AT-512CR Instrucciones De Instalación

Dodge Spirit/Plymouth
Acclaim 1989-1995
1. Unclip the dash trim bezel and remove. (Figure A)
2. Remove the screws securing the side console
trim pieces.
3. Pull the right trim piece out and remove (1) hex-
head bolt exposed.
4. Remove (1) hex-head bolt securing the
bottom-left corner of the factory head unit and
disconnect the wiring.
5. Cut and remove all mounting tabs on the radio
housing EXCEPT shaded tabs. (Figure B)
Continue to kit assembly, page 25
(Figure A) (Figure B)
Dash Disassembly
Dodge Van/Plymouth Van
1978-2003
1. Open the glove box and remove (2) Phillips
screws exposed.
2. Remove (5) Phillips screws from the bottom of the
dash trim bezel.
3. Unclip the top edge of the bezel and remove.
(Figure A)
4. Remove (2) 3/8" hex-head screws securing the
factory head unit and disconnect the wiring.
5. Cut and remove all mounting tabs on the radio
housing EXCEPT shaded tabs. (Figure B)
Continue to kit assembly, page 25
(Figure A) (Figure B)
21
Ford Aerostar
1985-1991
1. Remove (2) Phillips screws from the base of the
dash panel. (Figure A)
2. Pry down on the (2) tabs located at the top of the
radio trim bezel and remove the bezel.
3. Remove (4) screws securing the factory head unit
and disconnect the wiring.
4. Cut and remove all mounting tabs on the radio
housing EXCEPT shaded tabs. (Figure B)
Continue to kit assembly, page 25
(Figure A) (Figure B)