Jeep Wrangler 1997-2002; Lincoln Continental 1985-1987 - Metra AT-512CR Instrucciones De Instalación

Jeep Wrangler
1997-2002
1. Remove the ashtray and (1) Phillips screw exposed
in the ashtray cavity. (Figure A)
2. Pry out on the top cover of the instrument panel
and remove (2) Phillips screws exposed.
3. Pry out on the bottom edge of the dash trim bezel
and remove.
4. Remove (2) 3/8" hex-head screws securing the
factory head unit and disconnect the wiring.
5. Cut and remove all mounting tabs on the radio
housing EXCEPT shaded tabs. (Figure B)
Continue to kit assembly, page 25
(Figure A) (Figure B)
Dash Disassembly
Lincoln Continental
1985-1987
1. Remove (2) #8 Phillips screws below the
radio opening.
2. Open the ashtray and remove (2) #8 Phillips
screws (it is NOT necessary to remove the
center screw).
3. Unclip the dash trim bezel and remove.
4. Remove (4) hex-head screws securing the factory
head unit and disconnect the wiring. (Figure A)
5. Cut and remove all mounting tabs on the radio
housing EXCEPT shaded tabs. (Figure B)
Continue to kit assembly, page 25
(Figure A) (Figure B)
24
Lincoln Mark VII
1984-1989
1. Pry out on the dash trim bezel
and remove. (Figure A)
2. Remove (4) 5mm hex-head sheet
metal screws securing the factory head unit and
disconnect the wiring.
3. Cut and remove all mounting tabs on the radio
housing EXCEPT shaded tabs. (Figure B)
Continue to kit assembly, page 25
(Figure A) (Figure B)