Dash Disassembly; Kit Assembly - Metra AT-512CR Instrucciones De Instalación

Ocultar thumbs Ver también para AT-512CR:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Dash Disassembly

Dodge Dakota 2001-2004
Durango 2001-2003
1. Remove (3) T-20 Torx screws
from the bottom edge of the
panel below the steering column
and unsnap to remove panel.
(Figure A)
2. Remove (2) Phillips screws from
the instrument cluster panel above
gauges. (Figure A)
3. Remove (3) T-20 Torx screws from
the bottom of the steering column
shroud and unsnap and remove
the top half of the shroud.
(Figure A)
4. Unsnap and remove entire panel
surrounding radio, A/C controls,
and instrument cluster.
5. Remove (4) Phillips screws
securing radio. Disconnect and
remove radio.
Continue to kit assembly, page 10
2 screws
2 Screws
3 Screws
3 screws
3 screws
3 Screws
(Figure A)
DIN head unit
1. Slide the DIN cage into the radio
housing and secure by bending the
metal locking tabs down.
(Figure A)
2. Slide the aftermarket head unit into
the cage and secure. (Figure B)
3. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the unit for proper operation.
4. Reassemble dash in reverse order
of disassembly.
10

Kit Assembly

provision
(Figure A)
(Figure B)

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Aw-512crCf-512crIbr-512cr

Tabla de contenido