CYBEX gold ATON M + Manual Del Propietário página 42

INSTALLING THE BASE USING LATCH
8
Press the Lock-off down, until it locks into
8
place as shown.
If Lock-off does not lock, try loosening the
CLICK!
LATCH strap slightly.
9
Grab the Base at the Belt Guides and pull from
side to side and front to back to make sure the
base is installed correctly. The base should not
move more than 1 inch (2.5 cm) in any direction.
If the Base moves too much, open the Lock-
off, tension the LATCH Strap a little more and
try again. After this, if the Base still moves too
9
much, you may need to try a different vehicle
seat location or installation method, or both.
Install load leg, see page 36.
42