CYBEX gold ATON M + Manual Del Propietário página 63

3
Check the recline angle. Adjust the seat angle
until the red Level Line on the Infant Carrier is
level with the ground. A tightly rolled towel or
pool noodle may be placed under the Infant
Carrier near the vehicle seat back to adjust
the angle. See page 67.
The Aton M is allowed to touch the vehicle
seat(s) in front of it, as long the recline angle
of the Aton M is not affected.
ALWAYS have the handle locked in Position A
while using this child restraint in a vehicle.
4
Grab the Infant Carrier at the Belt Guides and
pull from side to side and front to back to
make sure it is installed correctly. The Infant
Carrier should not move more than 1 inch
(2.5 cm) in any direction.
If the Infant Carrier is next to a vehicle door
or panel, extend the adjacent L.S.P. (Linear
Side-impact Protection) device. See page 65.
If the Infant Carrier moves too much, tighten
the vehicle belts more and recheck. You
may try a different vehicle seat or installation
method, or both.
3
4
63