CYBEX gold ATON M + Manual Del Propietário página 59

To check if the vehicle belt is locked, after you
install the infant carrier, pull up firmly on the lap
belt between the Belt Guides. The belt should
remain tight if the vehicle system is locked.
Push Infant Carrier firmly into vehicle seat,
pressing down near the crotch strap between the
child's legs, while removing slack from lap belt.
Repeat for shoulder belt.
Make sure that vehicle belt buckle and hardware
do not interfere with the Infant Carrier.
3
Check the recline angle. Adjust the seat angle
until the red Level Line on the Infant Carrier is
level with the ground. A tightly rolled towel or
pool noodle may be placed under the Infant
Carrier, near the vehicle seat back to adjust the
angle, if necesarry. See page 67.
The Aton M is allowed to touch the vehicle seat(s)
in front of it, as long the recline angle of the
Aton M is not affected.
4
Grab the Infant Carrier at the Belt Guides and
pull from side to side and front to back to make
sure it is installed correctly. The Infant Carrier
should not move more than 1 inch (2.5 cm) in any
direction.
ALWAYS have the handle locked in Position A
while using this child restraint in a vehicle.
3
4
59