Avisos Normativos; Número De Identificación De Modelo Normativo; Fcc Statement; Notice To Users In Australia - HP Photosmart C4200 All-in-One Serie Manual Del Usuario

Capítulo 15

Avisos normativos

HP All-in-One cumple los requisitos de producto de las oficinas normativas de su país/región.
En esta sección se tratan los siguientes temas:
• Número de identificación de modelo normativo
•

FCC statement

•

Notice to users in Australia

•
Notice to users in Korea
•
VCCI (Class B) compliance statement for users in Japan
•
Notice to users in Japan about power cord
• Geräuschemission
• Declaración de conformidad (Unión Europea)
• Declaración de conformidad de HP Photosmart C4200 All-in-One series
Número de identificación de modelo normativo
A fin de identificar el modelo según las normativas, el producto dispone de un número de modelo
para normativas. El número de modelo para normativas de este producto es SNPRB-0721. El
número para normativas no debe confundirse con el nombre comercial (HP Photosmart
C4200 All-in-One series, etc.) o con los números de los productos (CC200A, etc.).
FCC statement
The United States Federal Communications Commission (in 47 CFR 15.105) has specified that the
following notice be brought to the attention of users of this product.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy, and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Modifications (part 15.21): The FCC requires the user to be notified that any changes or modifications
made to this device that are not expressly approved by HP may void the user's authority to operate
the equipment.
For further information, contact the Manager of Corporate Product Regulations, Hewlett-Packard
Company, 3000 Hanover Street, Palo Alto, CA 94304, (650) 857-1501.
Notice to users in Australia
Este equipo cumple con los requisitos EMC en Australia.
152 Información técnica