Atos Medical Provox XtraHME Instrucciones De Uso página 11

Remove Provox FlexiDerm when it has become loose or dirty. Carefully remove
the adhesive from the skin, using the finger lift tab. An adhesive remover
(described below) may be helpful for removing adhesives or glue. Always
clean the skin with a Provox Cleaning Towel and/or soap and water after use
of an adhesive remover. Dry the area carefully. Caution: When cleaning the
skin from e.g. residual glue, prevent particles/fluids from entering your stoma.
Provox StabiliBase
To apply the adhesive to your skin, first make sure the skin is clean and dry.
If needed, you can apply skin protection products (described below). Then
remove the center piece of the back-liner (Fig. 3.5, 3.6). Apply the adhesive
to the skin around your stoma (Fig. 3.7), and then remove the side pieces of the
back liner (Fig. 3.8). Gently massage the adhesive onto the skin to improve
adherence (Fig. 3.9).
Remove Provox StabiliBase when it has become loose or dirty. Carefully remove
the adhesive from the skin, using the finger lift tab. An adhesive remover
(described below) may be helpful for removing adhesives or glue. Always
clean the skin with a Provox Cleaning Towel and/or soap and water after use
of an adhesive remover. Dry the area carefully. Caution: When cleaning the
skin from e.g. residual glue, prevent particles/fluids from entering your stoma.
WARNINGS
• The adhesive may irritate the skin. Stop using the adhesive if skin irritation
develops and consult your clinician.
• Do not use the Provox Adhesives during radiotherapy that is delivered to the
area covered by the adhesive. Consult your clinician before you resume use
of the adhesive after radiation therapy.
• Reuse of the adhesive, by yourself or someone else, may cause transfer of
micro-organisms which can lead to infections.
• Reuse may also cause reduced efficiency of the adhesive properties which
can lead to air leakage during speech and reduced efficiency of the attached
HME.
• Only use genuine Provox system components that are intended for use with
Provox Adhesives. Other devices may cause personal injury or damage to
the products.
11