Atos Medical Provox XtraHME Instrucciones De Uso página 13

Adhesive Remover
Intended use
Adhesive Remover is used for removal of adhesives and glue residue from skin.
How to use Adhesive Remover
Apply the product on top of the adhesive. Grasp the finger lift tab and apply
more of the product at the edge and underneath the adhesive. Carefully remove
the adhesive and adhesive residue from the skin. Clean the skin with Provox
Cleaning Towel or water and soap afterwards.
PRECAUTIONS
• For external use only.
• Keep out of reach of children.
• Avoid contact with eyes. In the case of accidental contact, flush eyes well
with water.
• Do not apply to open wounds or mucous membranes.
• Vapor may be harmful - use with adequate ventilation.
• Hold breath while applying adhesive remover as inhalation can irritate the
airways.
• Be careful that the liquid does not drip into the stoma.
• Flammable. Do not use near heat, sparks or open flame.
• If swallowed, do not induce vomiting. Call physician.
• Avoid contact with painted/finished surfaces.
Provox® ShowerAid
Intended use
The Provox ShowerAid is used to temporarily replace the HME during shower-
ing. The ShowerAid can be placed in all Provox appliance holders.
How to use Provox ShowerAid
Attach and remove
Prior to entering the shower, remove the HME and insert Provox ShowerAid
with the opening facing down. After showering, remove Provox ShowerAid
and insert an HME (Fig. 4.1 – 4.4).
13