ISO DIN radio provision with pocket
1. Secure the pocket to the radio
brackets with the (4) #8 x 3/8"
Phillips truss-head screws
provided. (Figure A, Step 1)
2. Secure the bracket/pocket assembly
to the radio trim panel with the (4)
#8 x 3/8" Phillips truss-head screws
provided. (Figure A, Step 2)
3. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
4. Slide the radio into the assembly
and then secure with the screws
supplied with the radio. (Figure B)
Continue to Axxess
Interface Installation
Kit Assembly
Step 1
(Figure A)
®
99-7803G
Step 2
4
(Figure B)