Aa Motor Screw (10 In Motor; 1 In Hardware Pack); Cc 5.4M/M Lock Washer; Ff Canopy Mounting Screw - Harbor Breeze E-BFT52CB5C1 Manual Del Usuario

INITIAL INSTALLATION
2. Determine mounting method to use. (Fig. 2)
A. Downrod mount (normal or angled ceiling)
B. Closemount (normal ceiling only)
Important: If using the angle mount, check to make
sure the ceiling angle is not steeper than 19°.
3. Check to make sure blades (H) will be at least
30 in. from any obstruction. Check downrod (A)
length to ensure blades (H) are at least 7 ft.
above the floor. (Fig. 3)
4. Loosen canopy mounting screws (FF) in
slotted holes in canopy (B) and remove the other
two canopy mounting screws (FF)--save canopy
mounting screws (FF) for later use. Remove
mounting bracket (C) from canopy (B). (Fig. 4A)
Secure mounting bracket (C) to outlet box using
screws, spring washers, and flat washers
provided with the outlet box. (Fig. 4B)
*Note: It is very important that you use the
proper hardware when installing the mounting
bracket (C) as this will support the fan.
Important: If using the angle mount, make sure
open end of mounting bracket (C) is installed
facing the higher point of the ceiling.
5. Remove motor screws (AA) and lock washers
(CC) from underside of motor and save for blade
arm (G) attachment later on. [If there are plastic
motor blocks installed with the motor screws (AA)
and lock washers (CC), discard the plastic motor
blocks.] (Fig. 5)
Follow mounting instructions on pages 8 and 9 for
"Downrod Style Fan Mounting" or proceed to
pages 9 and 10 for "Closemount Style Fan
Mounting", depending on mounting method (A or
B) chosen in Step 2 above.
Fig. 4A
C
FF
B
Hardware Used
FF
Canopy Mounting Screw
Hardware Used
AA Motor Screw
CC
5.4 M/M Lock Washer
7
Fig. 2
A
B
Fig. 3
H
30 in.
min.
7 ft.
min.
Fig. 4B
C
FF
Fig. 5
AA
CC
E
x 10
x 4
x 10