Fan Operation - Harbor Breeze E-BFT52CB5C1 Manual Del Usuario

USING FAN WITHOUT LIGHT KIT (OPTIONAL)
2. Locate cap (M) in one of the hardware packs and
place firmly in hole in middle of switch housing cap.
Align holes in switch housing cap with holes in switch
housing and secure switch housing cap with three
screws that were removed from switch housing in Step 4
of "Final Installation" section (page 13). Tighten all three
screws securely. (Fig. 2)
3. The pull chain extension (J) supplied in one of
the hardware packs or a custom pull chain
extension (not included) may be attached to fan
pull chain. (Fig. 3)

FAN OPERATION

1. The pull chain located on the switch housing has four
positions to control fan speed. One pull is HIGH, two is
MEDIUM, three is LOW and four turns the fan OFF.
(Fig. 1)
2. The pull chain on the light kit fitter (D) is used to turn
the light ON or OFF. (Fig. 2)
Switch
Housing
E
Switch
Housing
16
Fig. 2
M
Switch
Housing Cap
Fig. 3
J
Fig. 1
Fig. 2
E