SATA J Serie Manual Del Uso página 14

Amoladora angular sin escobillas de batería de litio de 18v (100mm/125mm)
Ocultar thumbs Ver también para J Serie:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 89
General safety warning of electric tool :
Warning:
Read all safety warnings, instructions, diagrams and regulations provided with the electric tool. Failure to follow the
instructions listed below may result in electric shock, fire and/or serious injury.
Keep all warnings and instruction for review.
"Electric tool" in the warnings refers to the electric tool driven by mains supply(wired) or the battery(wireless).
Workplace safety:
1 ) Keep the work area clean and bright. Disordered and dark site may cause accidents.
2) Do not operate the electric tool in the explosive environment such as the flammable liquid, gas or dust. The spark generated by the
electric tool will ignite the dust or gas.
3) Keep away from children and bystanders when operating the electric tool. Inattention may cause you to lose control of tool.
Electrical Safety:
1 ) Plug of electric tool shall be supported by the socket. Never modify the plug in any way. Any change-over plug shall not be used for
the electric tool to be grounded. Unmodified plug and corresponding socket will reduce the risk of electric shock.
2) Do not contact the grounded surface such as the pipe, cooling fin and refrigerator. If your body is grounded, the risk of electric
shock will increase.
3) Do not expose the electric tool to the rain or moisture. Water entering the electric tool will increase the risk of electric shock.
4) Do not abuse the cord. Never carry, pull the electric tool with cord or pull out its plug. Keep the cord away from heat source, oil,
sharp edges or moving parts. Damaged or entangled cords may increase the risk of electric shock.
5) For the outdoor application, an extension cord for outdoor use shall be used. A cord suitable for outdoor will reduce the risk of
electric shock.
6) If it is inevitable to operate the electric tool in the humid conditions, the residual current device(RCD)shall be used. RCD is able
to reduce the risk of electric shock.
Note: "residual current device(RCD)" may be replaced by the "ground fault circuit interrupter(GFCI)" or "earth leakage circuit
breaker(ELCB)".
Personal safety:
1 ) Keep alert and awake when operating the electric tool. Do not operate the electric tool when you are tired or have medication,
alcohol or a therapeutic response. Instantaneous negligence in the operation of electric tool may result in serious personal injury.
2) Wear the personal protective equipment. Always wear the goggles. Protective devices, such as the dust mask, anti-slip safety shoes,
helmet, listening protection, etc., are able to reduce the personal injury.
3) Prevent the accidental starting. Make sure that the switch is turned off when connecting the power supply and/or battery box,
picking up or carrying the tool. Putting the finger on the switch or powering on when the switch is turned on may result in the
danger.
4) Remove all adjustment keys or wrenches before turning on the electric tool. A wrench or key left on the rotating part of electric tool
may cause the personal injury.
5) Do not stretch your hands excessively. Always pay attention to the foothold and body balance. This provides excellent control of
electric tool in unexpected situations.
6) Dress properly. Do not wear loose clothing or jewelry. Keep your hair and clothes away from moving parts.
Loose clothes, accessories or long hair may get caught in moving parts.
7) If a device for connecting the chip conveyor and dust collector is provided, make sure that they are connected well and used
properly. Dust collector is able to reduce the risk of dust.
14
51090
中文
EN
DE
RU
KO
PT
JA
ES

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

51090

Tabla de contenido