SATA J Serie Manual Del Uso página 20

Operation guideline:
Caution:
Please read the instruction carefully before operating the machine.
Before the use:
1 ） Charging:
This charger and machine shall be used together. Do not use other chargers.
The machine has a protection circuit. When the battery is low, the protection circuit is turned on and the machine stops rotating.
The machine may become hot under the high temperatures or after a long period of operation. At this time, do not charge
immediately but wait until the battery is cooled. Otherwise, the service life of battery will be shortened or the charging failure may
be caused due to overheating.
For the first charging or after a long period of storage, the efficiency of first charging may only reach about 60%. After 2-3 charging
and discharging cycles, the battery efficiency may reach 100%.
2） Installation and removal of battery pack（see Figure A）:
Press the lock buttons on both sides of battery pack and pull it out. To insert the battery pack, simply push it into the machine. Avoid
the excessive force.
Assembly:
Warning:
When installing or replacing the accessories, turn off the switch and remove the battery pack. Otherwise the serious injury
may occur.
1 ） Installation of side handle（Figure B）:
Note:
Be sure to install the side handle securely before operation.
Align the side handle with the threaded hole in the gearbox and turn them clockwise until the side handle is tightened;
2） Installation of shield and wheel（Figure C）:
Warning:
The cut-off wheel is equipped with a fully-closed shield and the grinding wheel blade is equipped with a semi-closed shield.
Moreover, the diameter of wheel shall match that of shield.
The thickness of inner pressure plate disk is greater than 3MM external pressure plate
The thickness of inner pressure plate disk is less than 3MM external pressure plate
3） Installation or removal of shield（see Figure D）:
Warning:
When the tool is used, the shield shall be mounted on the tool and the closed side of shield shall always face the operator!
20
51090
中文
EN DE RU KO PT JA ES