Sterling 2375 Serie Guia De Instalacion página 10

Top Surface
6. Assemble the Walls
If the valving has not been installed, install it now following the valve manufacturer's instructions.
Position the walls upright on a clean, flat surface with the flanges mating as shown.
Make sure the walls are both resting flat on the floor and are flush.
Apply a minimum 1/4" (6 mm) bead of mildew-resistant clear 100% silicone sealant on one of the
mating surfaces between the walls. Remove excess sealant.
Reposition the walls together and assemble the bolt, washers, and nut at each location.
Wrench tighten. Do not overtighten.
Glue a 1x2 x 72" (182.9 cm) stud to the back outer edge of each shower wall to provide a solid
attachment for the wall jambs.
1100676-2-C
Apply silicone
sealant here.
Glue 1x2 x 72"
(182.9 cm) stud to
back of each wall.
Back Side Shown
Washer
Bolt
Washer
3/8" (1 cm)
10
Washer
Nut
1x2 x 72" (182.9 cm)
Stud
Sterling