Sterling 2375 Serie Guia De Instalacion página 15

Nut
Screw
Bulb
Seal
Slot
Screw
Nut
14. Install the Bulb Seal into Strike Side Fixed Panel
Trim the seal 2" (5.1 cm) shorter than the slot length.
Slide the bulb seal down into the slot on the strike side fixed panel frame. It should be 1" (2.5 cm)
below the top edge of the slot when fully installed.
15. Install the Connectors
NOTE: The hole in the connector should be closest to the outside of the shower as shown. This is critical
for shower door installation.
Place the connector against the side frame of the side fixed panel.
Insert an 8-32 x 3/8" screw through the connector.
Slide an 8-32 nut into the slot on each side frame of the side fixed panel.
Tighten the screw, connector, side frame and nut.
Repeat the steps with each of the three remaining connectors.
16. Install the Side Fixed Panels
NOTE: Perform the procedures below from the inside of the shower.
Place the side fixed panel on the top of the receptor and slide the side fixed panel into the wall
jamb.
Allow the side fixed panel to rest on the receptor.
Repeat this procedure with the remaining side fixed panel.
Sterling
Connector
Bulb
Seal
Wall Jamb
15
Side Fixed
Panel
1100676-2-C