Sterling 2375 Serie Guia De Instalacion página 20

Inside Handle
Spacer
Handle Setscrew
Outside
Handle
Spacer
Etched
Logo
Seal here, outside only.
21. Install the Handles
Thread the setscrew into the handle with the Sterling logo.
Slide a spacer over the setscrew.
Slide the handle assembly through the hole in the glass door, making sure the Sterling logo is facing
the outside of the shower. Do not fully tighten.
Slide the second spacer over the other end of the setscrew.
Thread the second handle onto the setscrew.
Fully tighten both of the handles evenly, making sure the Sterling logo is properly oriented.
22. Install the Seal onto Bottom Door Panel
Trim the bottom seal to fit.
Orient the water dam toward the inside of the shower and press the bottom seal onto the bottom of
the door panel
23. Seal the Outside Frame
Apply 100% silicone sealant to:
• the outside of the shower where the wall jamb meets the wall.
• the outside of the shower where the bottom track meets the floor.
• the seam between the bottom track and the wall jamb.
1100676-2-C
Hole
Seal here, outside only.
Bridge Member
20
Glass Door Panel
Place inside
the shower.
Bottom Seal
Sterling