Tools And Materials; Before You Begin - Sterling 2375 Serie Guia De Instalacion

Thank You For Choosing Sterling
We appreciate your commitment to Sterling value. Please take a few minutes to review this manual before
you start installation. If you encounter any installation or performance problems, please don't hesitate to
contact us. Our phone numbers are listed within this manual. Thanks again for choosing Sterling.

Tools and Materials

Center Punch
Pencil
Plumbers
Level
Putty
Clear 100%
Panel Adhesive
Silicone Sealant
TM
Liquid Nails
(Mildew Resistant)
(Recommended)

Before You Begin

WARNING: Risk of personal injury. Do not cut the tempered glass. If the glass is cut, the glass
will shatter and may cause personal injury.
CAUTION: Risk of personal injury. Always wear safety glasses when cutting materials.
CAUTION: Risk of property damage. Select panel adhesive recommended for use with polystyrene
surfaces. This will ensure that the flat panels and corner panel will properly adhere to the walls to
create a watertight seal.
CAUTION: Risk of property damage. Select sealant recommended for use with polystyrene
surfaces. This will ensure that the outside of the shower door frame will properly seal to the
shower base and walls to prevent water leakage.
CAUTION: Risk of property damage. After completing the installation, do not use the shower for
24 hours. This will allow the panel adhesive and sealant to properly cure.
NOTICE: This shower door is designed to be specifically paired with a Sterling shower module. Do not
install this shower door if you do not have a Sterling shower module installed.
NOTE: When using a retractable case tape measure, make sure you add the length of the case to the
measurement or measure in a manner that excludes the case.
Check all local building codes prior to installation.
The shower door can be installed with the door opening to either the right or left. Install the door
with the pivot side away from the showerhead for best results.
The illustrations and instructions in this guide are for right pivot installations. Left pivot
installations will be opposite of what is illustrated and described unless specific directions are given.
Lay out and identify all of the parts. Inspect them for damage.
Return the glass panels to their packaging and place them in a safe area until they are needed.
If you are replacing an existing fixture, confirm the new model will fit before removing the old
fixture.
1100676-2-C
File
Safety
Glasses
Tape
Measure
C-Clamp
Shims
Masking
Tape
Caulk Gun
Claw Hammer
Scissors
Square
Phillips
Drill & Assorted
Screwdriver
Drill Bits
2
Plus:
• Conventional
woodworking tools and
material
• Drop cloth
• 2x4s or 2x6s
• Hole saw or jigsaw
with fine tooth blade
(32 teeth per inch)
• Furring Strips
• Foam Adhesive
• 1x2 x 72" (182.9 cm)
Board
Sterling