Sterling 2375 Serie Guia De Instalacion página 19

Screw
Back Plate
Foam Pad
20. Install the Door Panel
Install the Hinges
NOTE: The clean coat surface of the panel should be towards the inside of the shower.
Attach the foam pad, with the hole over the shaft, to L shaped hinge on the side that will be facing
the glass.
Position the shaft in the hole in the top of the door panel on the non-coated side of the glass with
the overhang on top of the panel.
Slide the bushing into the hole in shower door and over shaft on L shaped hinge.
Position the back plate so it is lined up with the hole in the glass.
Thread the screw into the shaft and carefully tighten with a screwdriver. Do not overtighten.
Repeat steps for bottom panel.
Attach the Door Panel
Lift the door panel and align the pivot hole closest to the edge of the door side frame over the
bottom pivot pin. Lower the door.
Align the top pivot hole of the door side frame with the hole in the connector block.
Insert the long end of the pivot pin through the connector block into the pivot hole of the door side
frame.
Making Adjustments
If adjustments are required, loosen the hinge screw and plate.
Make adjustments.
Tighten the hinge screw.
Sterling
Bushing
19
Top Pivot Pin
Bottom
Pivot Pin
1100676-2-C