Install The Plumbing - Sterling 2375 Serie Guia De Instalacion

Note: The control should be centered
between the studs. Adjustment of the
control plumbing and location may be
needed if the wall is not plumb.
8-1/2"
(21.6 cm)
8-1/2"
(21.6 cm)
16"
(40.6 cm)
40-3/8"
(102.6 cm)
Ledger Board
1. Construct the Stud Framing
NOTE: Check the dimensions of the showerhead trim ring if possible. If the diameter of the trim ring
exceeds 2-1/8" (5.4 cm), then mount the shower arm above the shower wall in an appropriate spot.
The showerhead may be installed in the shower wall or above the shower wall. Take into account
the height of the shower users when determining the installation location. The dimensions provided
are for a shower wall installation only.
Construct the framing according to the roughing-in and framing diagrams.
Add any bridging or support needed if you are installing grab bars or towel bars. Refer to the
accessory manufacturer's instructions.
Cut a 2x4 ledger board to 34" (86.4 cm) long and a second 34" (86.4 cm) less the width of the board.
The top of the ledger boards should be 4-3/8" (11.1 cm) high. Attach the ledger boards to the studs
to provide rim support. Attach the 34" (86.4 cm) board first, then the shorter board so it butts
against the first board.
The plumbing may be installed in the shower wall or above the shower wall. The supplied
dimensions should be used on either wall.
If the unit is installed against a masonry wall, use furring strips to secure the unit. The furring strip
configuration should match the stud configuration shown.

2. Install the Plumbing

Locate the drain according to the dimensions shown above. Measure and cut the drain hole opening
in the floor and install the rough drain lines.
Install the rough plumbing at the dimension shown above. The rough plumbing should be installed
before the unit is installed.
1100676-2-C
40-3/8"
(102.6 cm)
8"
(20.3 cm)
16"
(40.6 cm)
9-7/8"
(25.1 cm)
34"
4-1/2"
(86.4 cm)
(11.4 cm) D.
9-7/8"
(25.1 cm)
Ledger Board
34" (86.4 cm)
Note:
This dimension is for mounting the
showerhead in the top of the shower wall.
If you are mounting the showerhead above
the showerwall, disregard this dimension
and adjust the plumbing accordingly.
4-3/8" (11.1 cm)
6
Optional
Optional
Sterling