Establishing The Electrical Connection - Abicor Binzel DAV Guia De Instalacion

6 Putting into operation

6.3 Establishing the electrical connection

EN - 10
Valve activation requires a digital robot output of 24 VDC at Imax. > 1.1 A or
a comparable switching contact.
 4 Scope of delivery on page EN-7
Switching inductive loads requires the use of a recovery diode D1 (1N4007).
The recommended installation site is the female connector at the solenoid
valve.
With option: Non-contact end position sensing
D1
14 12
Y1
Fig. 5 Establishing the electrical connection
S1 S2
With option:
Non-contact
end position sensing
S1
S2
DAV