Wire Cutting Device Dav; Drawing Wire - Abicor Binzel DAV Guia De Instalacion

DAV

6.4 Wire cutting device DAV

6.5 Drawing wire

1
X
1 Gas nozzle
Fig. 6 Wire cutting device DAV
1 Briefly trigger the current-less wire feeder.
2 Move the torch with the free wire end and the dimension X to the cutting
area of the wire cutter (2) .
The wire must lie against the fixed jaw, and the gas nozzle (1) must be directly
above the cutter.
Program the way points and commands as described in the flow chart.
 Fig. 7 Flow chart on page EN-12
3 Set the Cut robot signal.
4 After a brief waiting time, reset switching state.
5 Move torch out of the DAV toward the top.
NOTE
• Worn-out cutting edges may cause malfunctions. A cost- and time-saving
remedy is correcting the start-up position by a few millimeters. Only when
the entire cutting width of the cutter has been worn out, will a
replacement be required.
 9.1.1 Changing the cutter on page EN-14
Applies only in connection with a torch neck change system, for example ATS
rotor.
1 Remove the wire electrode that was cut off during the change procedure
and left in the change neck.
6 Putting into operation
2 Wire cutter
2
EN - 11