Setting Up The Desk; Levelling - Steelcase Flex Collection Desk Instrucciones De Uso

_______________________________________________________________
Attach or detach connectors only when
the equipment is de-energised.
The plug of the desk must be easily
accessible at all times.
Figure 4-2: Electrical connections
Information on the connections for the
motor controller is also provided under:
http://www.linak.de/deskline/?id3=2396
DL12, DL14, DB14, DL17

4.7 Setting up the desk

Setup and use of the product requires detailed
planning. For this Steelcase offers the services of a
separate planning department.
The partially-assembled units of the Flex Height-
Adjustable Desk are usually supplied via retailers or
directly from the manufacturer.
The installation location must meet the following
requirements:
■ The floor must have sufficient load-bearing
capacity
■ Level placement surface
■ Temperature range: +5 °C to +40 °C.
■ Max. rel. humidity: 80 %

4.8 Levelling

There is an adjustment wheel on each foot of the
desk that can be used to raise the desktop as much
as 1.0 cm to compensate for unevenness of the floor.
For a desk that has already been assembled: before
levelling, remove any objects from the desktop.
156631
Fig. 4-3: Flex Height-Adjustable Desk height compensation
1
Adjustment wheel
2
Roller
Move the adjusting wheel to screw in or screw

out the rollers.
Desk height increases or decreases.
=
>
Transport and storage
11
EN