_______________________________________________________________
For the power connection
Insert the mains plug into a power point supply-
ing 220/230 V.
Prior to putting the desk in service, it is
necessary to perform a manual reset.
The instructions for this procedure can be
found in the description of the
corresponding control panel.
5.2.2 Operating panel
Simple Touch
operating panel
The control panel is located on the left- or right-hand
side at the underside of the desktop.
Figure 5-1: Simple Touch operating panel buttons
1
Control panel
2
Toggle switch "up"
3
Toggle switch "down"
ATTENTION
Risk of damage to control panel!
Do not lean on the control
panel.
Do not place any objects on the
control panel.
Do not pour liquids over the
control panel.
Simple Touch
Manual reset on
An end position calibration of the lowest desktop
position must be performed:
■
Prior to placing the desk in service
■
When the actual desktop position no longer
matches the displayed desktop position.
156631
operating panel
Operating and adjusting
■
When a previously configured motor controller is
used in a different electrically height adjustable
workstation of the same design.
Press the operating panel down-
wards and hold it down until it
reaches the lower end position.
Release the operating panel for 1
second.
Press the operating panel down
again for approx. 5 sec. and hold it.
The desktop moves to the lower end
position and makes a short move-
ment.
Release the operating panel. The
system is now ready for operation.
If the control panel is released before the
process is completed, the manual
resetting process will be interrupted and
must be restarted.
Adjusting the desk height with
operating panel
Before performing the height adjustment, you must
ensure that:
■
No one is in the lifting range. No objects (such as
open doors or windows) are in or protrude into
the lifting range.
■
There are no objects in the lift range of the lift
column.
■
No one is on the desk.
■
The maximum permissible load-carrying capacity
of the desk is not exceeded (see
data
).
■
No heavy loads are on the desktop. Heavy loads
make the height adjustment more difficult.
The desktop is level. If the floor is uneven, align the
desktop with the adjusting screws on the feet.
EN
Simple Touch
3.1 Technical
13