_______________________________________________________________
Ensure that the connecting cables for the
devices on the desk are long enough.
Press the operating panel
A lift movement takes place only:
■
As long as the corresponding operating panel is
pressed.
■
As long as the maximum load (approx. 75 kg) is
not exceeded.
ATTENTION
Risk of damage to the desktop!
If desktop movement occurs on
one side only or unevenly:
Release the operating panel
EN
immediately to stop the
movement.
Determine the cause using the
fault-finding table (see Error
messages on the display of the
Active Touch operating panel).
Consult a service technician if
necessary.
Active Touch
5.2.3
The Active Touch operating panel allows the storing
of two positions.
5 Operating and adjusting
to set the memory positions.
14
downward or upward until the
lower end position / upper end
position (programmed desktop
position) is reached.
operating panel
describes how
Operating and adjusting
Figure 5-2: Operating panel Active Touch variant
1
Toggle switch "down"
2
Toggle switch "up"
3
Display
4
Button "1" (MEM1 – memory position 1)
5
Button "2" (MEM2 – memory position 2)
6
Button
= "REMINDER" interval
Active Touch
Manual reset on
An end position calibration of the lowest desktop
position must be performed:
■
Prior to placing the desk in service
When the actual desktop position no longer
matches the displayed desktop position.
Press the operating panel down-
wards and hold it down until it
reaches the lower end position.
Release the operating panel for 1
second.
Press the operating panel down
again for approx. 5 sec. and hold it.
The desktop moves to the lower end
position and makes a short move-
ment.
Release the operating panel. The
system is now ready for operation.
operating panel
156631