Troubleshooting - GreenWorks STE304 Manual Del Operador

EN
The recommended ambient temperature range:
Item
String trimmer storage tem-
perature range
String trimmer operation
temperature range
Battery charging temperature
range
Charger operation tempera-
ture range
Battery storage temperature
range
Battery discharging tempera-
ture range
13

TROUBLESHOOTING

Problem Possible Cause
The ma- No electrical con-
chine does tact between the
not start machine and the
when you battery pack.
push the
trigger.
The battery pack is
depleted.
The lock-out but-
ton and trigger are
not pushed at the
same time.
English
Temperature
32°F (0°C) - 113°F (45°C)
32°F (0°C) - 113°F (45°C)
39°F (4°C) - 104°F (40°C)
39°F (4°C) - 104°F (40°C)
32°F (0°C) - 113°F (45°C)
32°F (0°C) - 113°F (45°C)
Solution
1. Remove battery pack.
2. Check contact and in-
stall the battery pack
again.
Charge the battery pack.
1. Pull the lock-out but-
ton and hold it.
2. Pull the trigger to start
the machine.
Problem Possible Cause
The ma- The guard is not
chine stops attached to the ma-
when you chine.
cut.
Heavy cutting line
is used.
The grass winds
around the motor
shaft or the trim-
mer head.
The motor is over-
loaded.
The battery pack
or machine is too
hot.
The battery pack is
disconnected from
the tool.
The battery pack is
depleted.
The line Lines are welded
does not ad- to themselves.
vance.
Not enough line
on spool.
Lines are worn too
short.
Lines are tangled
on spool.
12
Solution
Remove the battery pack
and attach the guard to
the machine.
Use only with the nylon
cutting line of 0.080" (2.0
mm) diameter.
1. Stop the machine.
2. Remove the battery
pack.
3. Remove the grass from
the motor shaft and trim-
mer head.
1. Remove the trimmer
head from the grass.
2. The motor will recover
to work as soon as the
load is removed.
3. When you cut, move
the trimmer head in and
out of the grass to be cut
and remove no more than
8" in pass.
1. Cool the battery pack
until its function returns
to normal.
2. Cool the machine for
approximately 10 mi-
nutes.
Install the battery pack
again.
Charge the battery pack.
Lubricate with silicone
spray.
Install more line.
Advance the cutting line.
1. Remove the lines from
the spool.
2. Wind the lines.