Attach The Edge Guide; Attach The Guard; Assemble The Shaft - GreenWorks STE304 Manual Del Operador

WARNING
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
8.2

ATTACH THE EDGE GUIDE

The edge guide can limit the cutting range of the machine
and decrease the risk of the damage caused by the rotating
cutting line.
1. Insert the edge guide into the two holes on the housing
for fitment.
2. The edge guide can be flipped up for storage.
8.3

ATTACH THE GUARD

WARNING
Do not touch the cut-off blade.
1. Remove the screws from the trimmer head with a Phillips
head screwdriver (not included).
2. Put the guard onto the trimmer head.
3. Align the screw holes on the guard with the screw holes
on the trimmer head.
NOTE
English
4. Tighten the screws.
8.4

ASSEMBLE THE SHAFT

1. Loosen the screw on the coupler (7).
2. Push in the release button on the lower shaft (8).
3. Align the release button (12) with the positioning hole
(13) and slide the two shafts together.
12
4. Turn the lower shaft until the button locks into the
positioning hole.
5. Tighten the screw with the hex wrench (14).
8
7
7
6
13
14
Hex screw
EN