Harbor Breeze KEYPORT Manual Del Usuario página 11

STANDARD OR ANGLE MOUNTING INSTRUCTIONS
5. If you decided to cut back the lead wire in Step 4,
strip 1/2 in. of insulation from the end of the white
wire. Twist the stripped ends of each strand of wire
within the insulation with pliers. Repeat this step for
black, blue (if applicable) and green wires.
Important:
If you did not cut back the lead wires in
Step 4, Step 5 is not necessary and you
may proceed to Step 6.
6. Install the ball end of the downrod (A) into the mounting
bracket (E) opening. Align the slot in the ball with the
tab in the mounting bracket (E). The rod should not
rotate if it is done correctly.
DANGER: Failure to align the slot in the ball
with the tab may result in serious injury or death.
Proceed to the Wiring section of this manual.
5
6
11
A
Lowes.com/harborbreeze
E