Initial Installation - Harbor Breeze KEYPORT Manual Del Usuario

INITIAL INSTALLATION

1. Turn off the circuit breakers and the wall switch to the
fan supply line leads.
DANGER: Failure to disconnect the power
supply prior to installation may result in serious injury
or death.
2. Ensure that the blades (K) will be at least 30 in. from
any obstructions. Also check the downrod (A) length
to ensure the blades (K) will be at least 7 ft. above
the floor.
3. Secure the mounting bracket (E) to the outlet box
using screws, spring washers, and flat washers
provided with the outlet box (not included).

Note: It is very important that you use the proper
hardware when installing the mounting bracket
(E) as this will support the fan.
Important:
If using the angle mount, ensure that the
open end of the mounting bracket (E) is
installed facing the higher point of the
ceiling.
1
2
A
7 ft. Min.
3
7
K
Lowes.com/harborbreeze
30 in. Min.
E