LIGHT KIT INSTALLATION
3. Install the bulbs (L) into the sockets on the switch
housing (O).
Important:
Make sure you allow the bulbs (L) and
light kit to cool before you replace the
bulbs.
4. Remove the pre-installed flat washer (II), nut (HH),
and finial plate (M), and finial (N) from the switch
housing (O).
Hardware Used
HH
Nut
II
Flat Washer
5. Install the glass shade (I) upward through the nipple
portion of the switch housing (O) and secure with the
flat washer (II), nut (HH), and finial (M). Take care to
align the holes on the glass shade (I) and finial plate
(M), and finial (N) so that the pull chains can pass
through and move freely.
Hardware Used
HH
Nut
II
Flat Washer
3
4
x 1
x 1
5
x 1
x 1
19
L
O
HH
M
I
HH
M
Lowes.com/harborbreeze
O
II
N
O
II
N