MBM BME74T Manual De Uso E Instalación página 29

personnel of the manufacturer or by
technicians who are formally authori-
sed by the same. Failure to do so
exempts the manufacturer from any
liability for for any possible resulting
modifications or damage.
Upon arrival, check the integrity
of the appliance and its compo-
nents (e.g. power cord), prior to
use. In the presence of faults do not
start the appliance and contact the
nearest service centre.
Read the instructions before
acting.
to be performed. As far as personal
protective equipment is concerned,
the European Community has issued
Directives which the operators must
comply with. Noise ≤ 70 dB.
It is forbidden the installation of
stand alone equipment WI-
THOUT anti-tip kit (ACCES-
SORY). TOP versions excluded.
Before making the connections
check the technical data shown
on the rating plate of the appliance
and the technical data in this manual.
It is strictly forbidden to tamper
with or remove the plates and pic-
tograms applied to the equipment.
Disconnect all supplies (water
- gas - electrical) upstream the
appliance whenever you need
to work in safe conditions.
Connect the appliance in the
sequence of the water, then to
the gas network. Ensure there
are no leaks then proceed with the
connections to the mains.
The appliance is not designed
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
GENERAL AND SAFETY INFORMATION
Wear protective
equipment suitable
for the operations
- 5 -
to work in an explosive atmosphere
and as such its installation and use is
categorically prohibited in such envi-
ronments.
Position the entire structure, re-
specting the installation dimen-
sions and characteristics indi-
cated in the specific chapters of this
manual.
The appliance is not intended
for recessed installation. / The
appliance must be used in a
well ventilated area. / The appliance
must have free drainage (not hinde-
red or impeded by foreign bodies).
The gas equipment must be
installed beneath an extrac-
tion hood whose system must
have specifications in compliance
with the current regulations in the
country of use.
Once the appliance is connect-
ed to the power and drain
sources, it must remain static
(fixed) in the place of use and mainte-
nance. Incorrect connection may
cause danger.
Use where appropriate flexible
cable for connection to the
mains electricity supply with
characteristics not inferior to model
H07RN-F. The supply voltage suppor-
ted by the cable with the appliance
working must not differ from the nomi-
nal voltage value ± 15% shown at the
bottom of the technical data table.
The appliance must be includ-
ed in an "Equipotential" ground
discharge system.
Drainage of the appliance must
be conveyed into the grey water
discharge network in an open
"glass" unsiphoned formation.
The appliance must only be
used for the purposes indicat-
2.
EN