Stove Phase General Layout - Ravelli Rc 120 Touch steel Manual De Uso Y Mantenimiento

Stove phase general layout

PHASE
FINAL CLEANING
SWITCH ON
WAITING FOR FLAME
WORK AT MAX P
ROOM TEMPERATURE
MODULATION
THE GRATE
ECO STOP
START/RESTART WAIT
SWITCH ON RESTART
HOT SMOKE
OFF
WAIT FOR PELLETS
OUT OF
INFEED SCREW
OVERFLOW
GENERIC ALARM
Use and maintenance manual Rc-Rv 120 Touch steel
DESCRIPTION
The stove is in the switch off phase and the cooling phase has
not been completed yet.
The heater pre-heating phase has started and the pellets start to
fall into the grate.
The pellets ignite and take advantage of the heat in the intake air
that passes through the incandescent heater tube.
The stove has completed the switch on phase and runs at
maximum set power
The room temperature set has been reached.
Brazier cleaning phase is active (periodic function).
With Climate Comfort active, the stove switches to automatic
switch-off mode when the room temperature set is reached (see
the dedicated section).
Switch-on is requested but with the stove in cooling phase; once
this condition is met, it restarts automatically.
The HOT restart phase is activated.
Functioning is similar to the SWITCH ON phase
The maximum fume temperature threshold has been reached.
To facilitate cooling, the stove brings the capacity to a minimum
with ventilation at power level 5, leading to a decrease in fume
temperature.
The stove is off
When the switch-on request from ECO-STOP mode coincides
with an automatic switch-off condition (from the TIMER), the
stove turns on ensuring total cleaning of the brazier before
switching to FINAL CLEANING.
CONDITION: when the pellet setting (set pellets +5) is near the
continuous load condition.
SOLUTION: Set the value back to 0.
The stove is in alarm state; refer to the troubleshooting chapter.
Rev.1 11/03/2021
Pag.45