General Information - Sirona Cerec MC XL Anexo Al Manual Del Operador

Sirona Dental Systems GmbH
Supplement to Operating Instructions
62 38 344 D3439
D3439.201.04.03.02 04.2010
3

General information

Removing the remainder of the ceramic block
NOTICE
After completing a milling process, remove the remainder of the ceramic
block out of the block clamp.
Open the milling chamber door
NOTICE
If you have not used the milling unit for a rather long time, we recommend
you should switch it off and then open the milling chamber door so that the
milling chamber can dry out.
General information
5