G
SAFETY WARNINGS
Safety warnings must be read and understood before instrument is used. The following
safety information must be observed to insure maximum personal safety during the
operation of this instrument:
■ Do not use in wet environments.
■ It is recommended that wherever possible isolate the
circuit to be tested while connecting and disconnecting test leads.
■ Test leads and prods must be in good order, clean, and with
no broken or cracked insulation.
■ Replacement test lead fuses must be of the correct
type and rating.
■ This instrument must not be used if any part of it is damaged.
■ The unit is for intermittent tests only, it must not be used for
continuous monitoring of phase rotation.
■ Warnings and precautions must be read and understood before
an instrument is used. They must be observed during the
operation of this instrument.
Note: This instrument must only be used by suitably trained and
competent persons
CATIV - Measurement category IV: Equipment connected between the origin
of the low-voltage mains supply outside the building and the consumer unit.
CATIII - Measurement category III: Equipment connected between the
consumer unit and the electrical outlets.
CATII - Measurement category II: Equipment connected between the electrical
outlets and the user's equipment.
INTRODUCTION
The Megger PSI410 phase rotation indicator provides rapid indication of correct phase
sequence utilising a three dual coloured sequencing LED display and a specific audible tone.
To avoid the display rotating at the supply frequency the unit has been designed to
provide a slow rotational speed of the display to allow easy indication of rotation.
Dual phase colour coding has been adopted for the PSI410 to allow ease of use on
both Brown / Black / Grey and Red / Yellow / Blue colour coded supplies.
2