Repair And Warranty - Megger PSI410 Guia Del Usuario

REPAIR AND WARRANTY

The instrument contains static sensitive devices, and care must be taken in handling
the printed circuit board. If an instrument's protection has been impaired it should
not be used, but sent for repair by suitably trained and qualified personnel. The
protection is likely to be impaired if for example; it shows visible damage; fails to
perform the intended measurements; has been subjected to prolonged storage under
unfavourable conditions, or has been subjected to severe transport stresses.
Note: Any unauthorised prior repair or adjustment will automatically invalidate the
warranty.
INSTRUMENT REPAIR AND SPARE PARTS
For service requirements for Megger instruments contact:
Megger Limited
Archcliffe Road
Dover
Kent CT17 9EN
Tel: +44 (0) 1304 502 243
Fax: +44 (0) 1304 207 342
or an approved repair company.
Returning and Instrument for Repair
If it is necessary to return an instrument for repair, a Returns Authorisation number
must first be obtained by contacting one of the addresses shown. You will be asked to
provide key information, such as the instrument serial number and fault reported when
the number is issued. This will enable the Service Department to prepare in advance for
the receipt of your instrument, and to provide the best possible service to you.
The Returns Authorisation number should be clearly marked on the outside of the
product packaging, and on any related correspondence. The instrument should be
sent, freight paid to the appropriate address. If appropriate a copies of the original
purchase invoice and of the packing note, should be sent simultaneously by airmail
to expedite clearance through customs.
For instruments requiring repair outside the warranty period a repair estimate will be
submitted to the sender, if required, before work on the instrument commences. The
instrument is designed for use indoors or outdoors and is rated to IP54.
4