Würth 1952 006 720 Traducción Del Manual De Instrucciones De Servicio Original página 22

DE
GB
FR
INTRODUCTION:
It is compulsory to read this instruction manual before starting any
kind of action.
NL
The proper operation and full compliance of this product's
performance is guaranteed only if all the instructions provided in
ES
this manual are closely adhered to. We guarantee that this product
complies with the technical specifications described in this manual.
IT
The manufacturer shall not be held responsible for any improper
uses other than those described herein. Use protective work gloves,
protective footwear, hard hat and safety goggles.
PT
Misuse:
- This product should only be used as described in this
PL
documentation; any other use is considered improper.
- The manufacturer accepts no responsibility for any damage
DA
caused by the incorrect or unreasonable use of the equipment.
- Moreover, misuse shall also void the warranty.
EL
Take care of your tools:
- Be sure to store your tools in a clean state.
- Place the tools inside their original package.
USE
The wheel hubs described in this manual and the tools for the
assembly and disassembly of the CV joint are intended for the
following operations, to be performed on the axles of commercial
vehicles and vans:
1. Mechanical removal of the CV joint (also in combination with
the 16-TON mechadraulic cylinder e.g.: Würth 1952 004
070)
2. Insertion of the CV joint
3. Disconnection of the CV joint with 1- to 3-kg slide hammer (slide
hammer not supplied! - Optional 1.4-kg slide hammer Würth
1952 003 905/ +907)
4. Removal of the wheel hubs/floating axles and brake drums
with a 5- to 9-kg slide hammer (slide hammer not supplied! -
Optional 9-kg slide hammer Würth 1952 004 050)
5. Assembly of the wheel hubs.
The following conditions often make it difficult to remove
components:
1. Glued CV joints
2. Rusty CV joints, etc.
22
METHOD OF PREPARATION
1
2
3
M12x1.5
M12x1.5
M12x1.5