Front Stop Adjustment - Adjustable Trunnion - Blatchford ESK+ Stanceflex ESKSFP30 Instrucciones De Uso

9.2

Front Stop Adjustment - Adjustable Trunnion

The instructions in this section are for practitioner use only.
Fitted to the PSPC
1
Fully tighten front stop.
3
Apply a light extension load to the knee and
gradually unscrew the piston rod (lengthening
the cylinder) until the chassis edge is parallel with
the top of the shin.
Front Stop Adjustment - Non-Adjustable Intelligent Prosthesis
(As fitted to older SmartIP models.)
No adjustment is necessary when using these cylinders. They require the front stop to be fully
tightened as shown in Stage 1.
2
4
Note... The stop pads mounted in the
chassis and side plate are required to
support ML loading. Simultaneous full
contact between the stops and the shin
is NOT required.
Withdraw trunnion damp screw and
apply LOCTITE 222 to thread, re-
assemble and tighten.
*UNDER NO CIRCUMSTANCES MUST
THE PISTON ROD WITNESS LINE BE
VISIBLE BELOW THE TRUNNION.
12
Loosen trunnion
clamp screw.
Turn piston rod to
reveal thread and
apply Loctite 243.
Reassemble and
screw piston rod
fully home. The
chassis should now
be slightly flexed.
6 A/F -PSPC
938403PK1/1-0121