Publicidad
Idiomas disponibles
Idiomas disponibles
Manual Programming/SWC Button Reassignment:
If your vehicle is not listed for auto detection by the ASWC on the Axxess
website most vehicles can still be manually programmed to the ASWC by
following these steps:
* Note: Not every radio will have all the possible swc commands on the
steering wheel. Aftermarket radios that do not have Bluetooth will not rec-
ognize the PTT (Push To Talk) or On Hook / Off Hook commands, however
those buttons can be manually programmed to do other commands. Please
refer to the radios owners' manual or wireless remote for specific com-
mands the radio will recognize.
1) Complete connections to the vehicle and the aftermarket radio, making
sure the 3.5mm connector is connected.
* If this is the first time the ASWC is being installed in a vehicle:
2) Turn the ignition on; the led will start flashing rapidly.
3) After 10 seconds the ASWC will go into the LED feedback mode. After
the series of led flashes the led will stay in a slow constant flash state.
Or
* If the ASWC has been in a vehicle before:
2) Press and hold the reset button down for more then 10 seconds.
3) After the 10 seconds the led will begin a slow constant flash.
4) At this point press and hold the Volume Up button on the steering wheel
for 7 seconds until the led goes solid red. Now release the Volume Up
button and the led goes off. Volume Up has now been programmed.
11
Publicidad
