Publicidad
Idiomas disponibles
Idiomas disponibles
7th led flash is for Alpine*
8th led flash is for Visteon
9th led flash is for Valor
* Note: If the ASWC flashes 7 times and you do not have an Alpine radio
connected to it that means that the ASWC did not see any radio connected.
Verify the 3.5mm connector is connected to the SWC input on the radio.
12) Make sure the number of flashes match what radio you have installed.
13) If the led flashes match the radio then hold down the Volume Down
button until the led goes solid red.
14) Programming for the vehicle and the radio is now complete. Test out
the steering wheel control functions to make sure it works correctly.
If the led flashes do not match the radio you have connected, you must
manually program the ASWC to tell it what radio it is connected to.
1) To manually program the aftermarket radio, press and hold the Volume
Up button on the steering wheel control until the led goes solid red, then
release Volume Up.
2) At this point Eclipse is programmed.
If you are using an Eclipse radio go to step 3.
If you are using a different radio go to step 4.
3) Press and hold Volume Down for 5 seconds. The led will flash once then
go solid red indicating the programming has finished. Go enjoy your
radio.
4) If you have a different radio then Eclipse, press the Volume Up button
again till the led goes solid red, then release Volume Up. You have now
programmed Kenwood.
14
Publicidad
