Publicidad
Idiomas disponibles
Idiomas disponibles
7) You can end this half of the programming in 2 ways:
1) After the last button is programmed on your steering wheel (you do not
have to go through the whole list), hold down the Volume Up button for at
least 10 seconds. The led will go into the slow constant blink mode.
Or
2) After the 18th button is programmed or skipped the led will go back to
the slow constant blink mode.
* If at any time you get lost or mess up hold down the reset button on the
ASWC for more then 10 seconds. This will restart the manual program-
ming. Go back to step #4 and start again.
At this point you will now be in the Radio Identification mode.
8) Press and hold the Volume Down button for 5 seconds till the led starts
to flash quickly.
9) Release the Volume Down button.
10) After 4 seconds of the led flashing quickly the led will go out for 2
seconds.
11) Then the led will flash, up to 9 times, depending on what radio the
ASWC thinks it's connected to.
Here are the led blinks and which radio they represent:
1st led flash is for Eclipse
2nd led flash is for Kenwood
3rd led flash is for Clarion
4th led flash is for Sony and Dual
5th led flash is for JVC
6th led flash is for Pioneer and Jensen
13
Publicidad
