Publicidad
Idiomas disponibles
Idiomas disponibles
* If the ASWC was installed in a vehicle before:
2) Turn the ignition on, the led will flash slowly.
3) Hold down the reset button for more then 2 seconds but less then 10
seconds, the led will start flashing rapidly.
4) Perform action required for your particular vehicle as noted in the vehicle
info sheet.
5) After a couple of seconds the led should stop flashing and not light up for
2 seconds.
At this point do not push any buttons.
6) After the 2 seconds there will be a series of 7 flashes, some short and
some long.
7) The led will pause another 2 seconds then a series of 9 flashes.
8) This is the end of the auto detection stage. If the ASWC detected the
vehicle and the radio successfully the led will light up solid red.
9) Make sure the steering wheel control buttons function correctly in the
vehicle and enjoy your radio.
So what if the led does not light up solid red or the steering wheel controls
is not working correctly with the aftermarket radio?
Check out troubleshooting section right below.
8
Publicidad
